Start Printing - ATOMSTACK Cambrian Pro Manuel D'utilisation

a:Select the printing file
Power on, insert the TF card into the
motherboard card slot at the front of
the device. Click the "Print" button to
enter the file list, select a print file
and click to enter the print
information confirmation page

12.Start printing

b:Confirm the printer parameter
Before starting to print, you need to
confirm the printing information. After
confirming that it is correct, click the
"Start" button to start printing
c:Heat the heating bed
After starting to print, the device will first
heat the heating bed (heated to the
temperature set during slicing). The hot
bed heating is to make the bottom of the
model better bond with the heating bed.
d:Heat the nozzle
When the heating bed is heated to the
target temperature, the equipment will
start heating the nozzle. When the nozzle
is heated to the target temperature, the
printer will start printing. This process is
estimated to take a few minutes.