Loading The Material - ATOMSTACK Cambrian Pro Manuel D'utilisation

11.2 Loading the material

a:Trim the filament a:Trim the filament
Trim the starting section of the filament to Trim the starting section of the filament to
the pointed end as shown in the picture to the pointed end as shown in the picture to
facilitate the insertion of the nozzle facilitate the insertion of the nozzle
b:insert the filament into the extruder
Push the feed handle and insert the filament
into the round hole above the nozzle, all the
way to the nozzle. If it is difficult to insert,
try rotating the filament.
c:Hang the material on the bracket
Hang the material on the material as shown
in the figure, and the material is loaded.