Environmental Protection - Ayce GG6380E-3 Traduction De La Notice Originale

Storage
Caution: The generator must be stored at a frost-protected location.
1) Allow the generator to cool down and empty the tank.
2) Store the generator in a dry and well ventilated place.
3) Store the generator horizontally.
Transportation
1) Allow the generator to cool down.
2) Empty the tank.
3) Transport the machine horizontally.
Changing the engine oil
CAUTION: prolonged exposure to used engine oil is dangerous; always wash your
hands thoroughly after handling used engine oil.
1.
2. Place a oil collection tray under the drain plug.
3. Unscrew the drain plug, and allow the used engine oil to drain from the crank-
case into the oil collection tray.
NOTE: Drain the engine oil when the engine is warm, this will ensure the oil
flows out quicker.
Replace the drain plug and its seal ring.
6.

Environmental protection

One of the most damaging sources of pollution is oil; do not throw away used
engine oil in with your domestic trash or down drains and sinks. Place it in a leak
proof container and take it to your local waste disposal site.
TROUBLE SHOOTING
Before performing any maintenance or cleaning work, always turn off the engine
and wait until the generator has come to a standstill.
CONDITION PROBABLE CAUSE
Loose spark plug
Insufficient Loose cylinder
compression head bolt
Damaged gasket
Fuel
systems
problems
No fuel
Engine supplied to
won't start combustion
chamber
Low engine
output
Engine run
erratically
Sufficient
compression
Combustion
chamber
supplied
with fuel
Improper
grade
of fuel used
122 123
CORRECTIVE
ACTION
Tighten plug
properly
Tighten bolt
properly
Replace gasket
Insufficient
Pull rope
pulling speed
sharply
for starting rope
Foreign matter
Clean tank
in fuel tank
Clogged
Clean fuel line
fuel line
No fuel in tank Supply fuel
Fuel shutoff
Open valve
not open
Electric Spark plug dirty Remove carbon
systems with carbon or wipe up
problems or wet with fuel spark plug
Improper Damaged Replace
spark spark plug spark plug
Faulty
magneto
Improper
adjustment of Consult dealer
carburetor
Insufficient
Improper Pull rope
pulling speed
spark sharply
for starting rope
Check fuel
Overloading
Check
the working
condition
Overheating
GB