Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Handle
Fit the handle through the bolt on the frame of the generator.
Shock Absorption Bracket
Fit the bracket through the bolt on the frame of the generator.
1) INSTALL BATTERY
1)
Put the battery on the battery rack.
2)
Fix the battery by using the battery plate and battery retractor.
3)
Connect the red battery cables to "+" and the black battery cables to "-" and
lock the bolts.
2) STARTING THE ENGINE
NOTE:
a)
Do not connect the electric load or equipment before starting the engine.
b)
Turn the engine switch to "OFF".
1)
Turn the fuel cock lever to "ON".
2)
Turn the engine switch to "ON".
3)
Turn the choke lever to the "CHOKE" position. Not necessary if the
engine is warm.
Electric Star
Turn the key to the "START" position till the generator starts, then release it.
Recoil Start
1)
Pull the starter handle slowly till resistance is felt.
Return the handle to its original position and pull swiftly. Do not fully pull
out the rope. After starting, allow the starter handle to return to its
original position while still holding the handle.
2)
Turn the choke lever back to the "RUN" position.
3)
Warm up the engine without a load for a few minutes.
3) USING ELECTRIC POWER
1. AC APPLICATION (SINGLE VOLTAGE TYPE)
a)
Check the voltmeter for correct voltage.
b)
Ensure that electrical equipment is switched off before connecting to the
generator.
c)
Connect the plug(s) of the electrical equipment into the appropriate socket.
d)
Turn the engine switch to the "ON" position and turn on the electric
equipment.
CAUTION:
2. DC APPLICATION
a)
The 12 V circuit protector turns on automatically when the load current
The 12V DC outlet supply is not intended for use with sensitive devices,
b)
3. STOPPING THE ENGINE
a)
Turn off the power to the electric equipment or unplug the mains lead
from socket of the generator. Turn the AC switch to "OFF".
b)
Turn the engine switch to "OFF".
c)
Turn the fuel cock lever to "OFF".
110 111
GB
Publicité
Table des Matières
