Table Des Matières; Specified Use; General Safety Rules - Metabo MAG 32 Mode D'emploi

17027034_0710 MAG 32 MAG 50 NAFTA.book Seite 5 Mittwoch, 28. Juli 2010 10:03 10
Operating Instructions
Dear Customer,
Thank you for the trust you have placed in us by buying a Metabo power tool. Each Metabo power tool
is carefully tested and subject to strict quality controls by Metabo's quality assurance. Nevertheless, the
service life of a power tool depends to a great extent on you. Please observe the information contained
in these instructions and the enclosed documentation. The more carefully you treat your Metabo power
tool, the longer it will provide dependable service.
Contents
1 Specified Use
2 General Safety Rules
3 Specific Safety Rules
4 Functional Description
5 Initial Operation
5.1 Power-Supply Connection
6 Operation
6.1 Attaching the Securing Strap
6.2 Cooling Unit for Core Drilling
6.3 Adjusting the Gear, Speed and
Direction of Rotation (only applies
to MAG 50)
6.4 Switching on/Switch-on Sequence
6.5 Switching off the Driving Unit
6.6 Switching off the Magnet
6.7 Mounting on the Workpiece
6.8 Drilling
7 Cleaning, Maintenance
8 Troubleshooting
9 Accessories
10 Repairs
11 Environmental Protection
12 Technical Specifications

1 Specified Use

The magnetic drill stands MAG 32 and MAG 50 are
suitable for core drilling with suitable cutting edge
tools and for drilling with spiral drill bits in metal.
MAG 50 is also suitable for thread tapping.
The magnetic drill stand is designed for fastening
to a magnetisable, even metal surface and must
therefore have perfect adhesion. In conjunction
with the supplied securing strap, suitable for
working on vertical and angled surfaces and over-
head.
The user bears sole responsibility for any damage
caused by improper use.
Generally accepted accident prevention regula-
tions and the enclosed safety information must be
observed.

2 General Safety Rules

1 WARNING! Read and understand all
instructions.
Failure to follow all instructions listed below may
result in electric shock, fire and/or serious personal
injury.
SAVE THESE INSTRUCTIONS.
2 Work Area
2.1 Keep your work area clean and well lit.
Cluttered benches and dark areas invite accidents.
2.2 Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases, or dust. Power tools
create sparks which may ignite the dust or fumes.
2.3 Keep bystanders, children, and visitors
away while operating a power tool. Distractions
can cause you to lose control.
3 Electrical Safety
3.1 Grounded tools must be plugged into an
outlet properly installed and grounded in
accordance with all codes and ordinances.
Never remove the grounding prong or modify
the plug in any way. Do not use any adapter
plugs. Check with a qualified electrician if you
are in doubt as to whether the outlet is properly
grounded. If the tools should electrically
malfunction or break down, grounding provides a
low-resistance path to carry electricity away from
the user.
3.2 Avoid body contact with grounded surfaces
such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is grounded.
3.3 Don't expose power tools to rain or wet
conditions. Water entering a power tool will
increase the risk of electric shock.
3.4 Do not abuse the cord. Never use the cord
to carry the tools or pull the plug from an outlet.
Keep cord away from heat, oil, sharp edges or
moving parts. Replace damaged cords
immediately. Damaged cords increase the risk of
electric shock.
3.5 When operating a power tool outside, use
an outdoor extension cord marked "W-A" or
ENGLISH
ENG
5