Installing And Connecting - Airfree E40 Manuel D'instructions

Plug power cord to the nearest outlet.
Make sure the surface is dry (never place Airfree on wet floor or immerge in water) Make sure
side blue led is on. Switch on dimmer and the anti-stress light should glow from the top lid (1).
After 10 minutes the top lid should be warm.
Place Airfree on the floor. Do not install it under furniture or shelves, behind curtains as it will
reduce air flow and Airfree efficiency in reducing microorganisms.
Place each Airfree® in rooms up to 16m² for E40/P40 or 24m² for E60/P60 or 32m² for E80/
P80 or 50m² for E125/P125 or 60m² for P150. For larger rooms use proportionally additional
Airfree® units. The use of just one Airfree ® in rooms larger than recommended will reduce
Airfree® efficiency.
Airfree must be continuously on in the same room, 24 hours a day.
Airfree can only be used in rooms with minimum air volume of 330 cu. ft. (10 m3), free of
obstacles.
Airfree can be installed in rooms equipped with air conditioning and heating systems. However
it is recommended not to place Airfree nearby them to avoid potential interference in Airfree
air flow.
Do not place Airfree in the corridor to try to reach the whole house. In this case Airfree will only
reduce air pollution in the corridor area.
Airfree shall not be placed near doors or under windows to avoid sterilised air to exit the room.

Installing and Connecting

11
E
n
g
l
i
s
h