Installing And Connecting - Airfree Babyair E60 Manuel D'utilisation

Plug power cord into the nearest outlet. Make sure the surface is dry (never place Airfree
wet floor or immerge it in water). Make sure side led light is on. Adjust the night light intensity
with the touch sensor. After 10 minutes the top lid should be warm.
Place Airfree ® on a flat surface not exceeding 75 cm from the floor, not under furniture, shelves,
or behind curtains as it will reduce airflow and Airfree
Check if the area is compatible with the unit capacity to achieve best unit performance. Using
Airfree in rooms larger than its capacity will greatly reduce its purifying capacity.
Airfree ® must be continuously on in the same room, 24 hours a day.
Airfree ® is to be used in rooms with minimum air volume of 10 m
Airfree ® can be installed in rooms equipped with air conditioning and heating systems.
However it is recommended not to place it nearby to avoid potential interference in Airfree
air flow.
Airfree ® can be placed in corridors but the air sterilisation effects will barely have any effect
in connecting rooms.
Airfree ® shall not be placed near doors or under windows to avoid sterilised air to exit the
room.
To change night light intensity or to shut off, press the sensor on the top of Airfree´s logo. You
can choose the best light intensity or simply shut the lights off.

Installing and Connecting

6 6
® efficiency in reducing microorganisms.
³
.
® on
®