Publicité
Les langues disponibles
Les langues disponibles
The connection between the IP video door phone and POE switch must be ensured by a single cable
without any extra patch cords.
5. DEVICE CONFIGURATION
Refer to the technical system manual by scanning the following QR Code with the camera of your smartphone
or tablet to configure the device.
6. TECHNICAL SPECIFICATIONS
POE input voltage: ......................................................................................................................... 48-54 V
External power supply voltage
Max consumption: .................................................................................................................................... 12 W
S+, S- terminal outputs: ....................................................................................................... 25 mA @ 24 V
Display: .................................................................................................................................................. 7" TFT
Touchscreen: .................................................................................................................................. Capacitive
Resolution: ................................................................................................................................ 1024 x 600 px
Brightness: ...................................................................................................................................... 350 cd/m
Viewing Angle (H/V): ....................................................................................................................... 160° / 160°
Operating Temperature: .................................................................................................................. -5 to 45°C
IPerHOME CU Consumption: ................................................................................................................ 0.5 CU
Max number of video door phones on the POE ports of switch 1039/44: ..................................................... 2
Dimensions (LxHxP): ......................................................................................................... 212 x 138 x 24 mm
This product is intended to be powered by either any external power supply units, through
the connector J4 on the board CS1717-021 (15 W, 48 V
RJ45 (PoE) whose power supply conforms to the limited power source (LPS) requirements
and is protected against short circuits and power surges in accordance with the
EN 62368-1:2014+A11 requirements.
7. KEY TO SYMBOLS
Description
Symbol
Direct input voltage
See the installation manual of the device
DS1761-018
:...................................................................................... 48 V
(#)
) or PoE, through the connector
- min. 15 W
2
5
Publicité
