Comutech 100701 Mode D'emploi page 18

Avoid creating or working around any flames or sparks; flames or sparks can ignite the gasses
caused by charging and cause an explosion.
15. UNPACKING.
When unpacking, check to make sure that the item is intact and undamaged. If any parts are
missing or broken, please contact your dealer
Batteries draw as much power as they need from the charger. The charger does not force current
into the battery. When a battery is close to dead or very low charged, it will want to draw more
current. When a dead or low battery is charged, the charger's ammeter will register at the high
end. As the battery charges, the reading will move down toward the low end, resting on zero,
when the battery is fully charged.
JUMPSTARTER
Note: The ammeter shows the amount of current being drawn from the charger. lt does not show
what the charger is capable of delivering. When the battery is fully charged and registering zero
on the ammeter, a small charge will continue to move from the charger to the battery. If you do
not disconnect the charger from the battery, eventually the heat build up from the charge will
cause the battery acid to boil and overcharge the battery causing damage to the battery. You
must constantly monitor battery charging progress and if battery gets warm, stop charging it
immediately.
Note: When charging a battery with a built-in hydrometer eye, do not depend on the hydrometer
eye to determine the battery charge level.
SETUP.
About Charging Batteries
CHARGING
-Power
-Charging
-Full
ut
-Fa
1- positif
clamp(Red)
2- negatif
clamp(Black)
SWITCH
18