Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
18. RESET TO FACTORY SETTINGS
After this operation the equipment returns to the factory default settings.
Select
Imax
Imin
PUSH
0
Auto
<4s
Note: The counters of hours, starts, alarms and current of the last alarm will not be deleted.
19. ADITIONAL PROTECTIONS
Excessive start frequency detection
After a start the pump needs at least 120 seconds to assume the initial effort. If a new start
appears before the end of this time the temperature of the pump increase.
In the event of more that 30 sucessive starts preventing the pump to cool down, the excessive
start frequency alarm is activated. The pump stops, the alarm output is activated and the display
shows the message [FrEc- HIGH].
Anti-lock system. Jammed impeller preventive syst
Every 23 hours Vigilec Compact will run the pump for 1 second avoiding blockage of the
pump motor. Intended to avoid possible failures after long inactivity periods.
Phase failure protection (three phase pumps)
If in a three-phase installation one of the phases is interrupted or missing, in the power
supply to the equipment or in the output to the pump, a phase failure will occur. The
unit detects the problem and displays the fault [PHA]-[Err]. In order for this fault to be
detected, the underload setting (Imin) must not be set in "OFF".
Overvoltage protection
If the power supply exceeds the nominal value by more than 30%, the equipment stops
its operation. When the voltage returns to the correct value, operation will be restored.
38
Distribuido por Adajusa
Press
Imax
Imin
PUSH
0
Auto
<4s
Turn right
Imax
Imin
PUSH
0
Auto
<4s
RELEASE FOR 8 SEC
Confirm
Imax
Imin
PUSH
0
Auto
<4s
HOLD DOWN
AND DO NOT
Publicité
Table des Matières
