Front Display Settings; Display Messages - toscano vigilec compact V1M Guide D'utilisation

1. FRONT DISPLAY SETTINGS

Datalogger
and advanced
options
Low level
Pump ON
The rotative pushbutton is used to configure the various setting parameters (selection/
(1)
modification/confirmation), to select the MAN-OFF-AUTO operating mode, to reset a
motor failure or to interrupt a timer in progress (see pages 35 to 37)

2. DISPLAY MESSAGES

0ff
Auto
9. 3 A
3H
I
42
I I
35
x1gx frec
Err. PHa5
xand
5et
data
ea5y
f. re5
End
22
Distribuido por Adajusa
PUSH
0
<4s
Pump stopped.
Automatic mode activated.
Pump power consumption (A).
Time in hours.
Time in minutes.
Time in seconds (flow switch inhibition).
Excessive frequency of starts.
Phase failure or abnormal current absorbed by the pump (+40% of
the current threshold set in Imax).
Manual reset after a water shortage (without reset time set).
Enter the "Datalogger and advanced options" menu.
Datalogger.
"Easy" mode activated.
Reset the unit to factory defaults (Factory Reset).
Exit "Datalogger and advanced options".
Overload setting
Imax
Underload setting
Imin
Restart time setting
Inhibition time setting
(flow switch or reverse
pressure switch)
Alarm
Auto
Control settings knob
(1)