Hama Multi Mode D'emploi page 4

5.4. Alarm clock
Alarm clock settings
• Turn the setting wheel on the back of the alarm clock to set the desired alarm time.
• Move the slider switch to the ON or OFF position to activate / deactivate the alarm.
• When the alarm is activated, the control display next to the number 3 appears red, and appears grey
when the alarm is deactivated.
Stopping the alarm / Snooze function
• Once the alarm clock is activated, it is triggered at the corresponding time and a rising alarm signal
is heard. After this, the alarm clock is stopped automatically and triggered again at the set alarm
time.
• To stop the alarm clock prematurely, move the slider switch to the OFF position.
• Move the slider back to the ON position to activate the alarm clock for the set alarm time.
Note - Snooze function
• During the alarm signal, press the SNOOZE/LIGHT button to activate the snooze function. The
alarm signal is interrupted for 5 minutes and then triggered again.
• The snooze function can be triggered six times in a row.
5.5. Backlight
• Press the SNOOZE/LIGHT button to illuminate the clock face for around 5 seconds.
6. RESET function:
• If the clock is not set correctly for any reason, you can carry out a „reset".
• Use a metallic object (e.g. a needle) and short-circuit the time using the RESET button on the
back of the alarm clock. All hands move to the 12 o'clock position.
• After around 5-10 minutes (depending on how quickly the radio signal is received), the hands on
the clock will adjust automatically to the correct time.
7. Digital display
The display changes every 20 seconds. The following data is displayed in sequence:
• Date
• Room temperature
• Seconds
Each display appears for 20 seconds.
4