GoPro HERO 4 BLACK Mode D'emploi page 42

/ Multi-Shot Mode
CAPTURING TIME LAPSE OR NIGHT LAPSE PHOTOS
1. Select the desired multi-shot capture mode (Time Lapse or
Night Lapse):
a. Press the Power/Mode button [
to Multi-Shot mode.
b. Press the Settings/Tag button [
c. Press the Shutter/Select button [
to the desired capture mode (Time Lapse or Night Lapse).
d. Press the Settings/Tag button [
menu. The icon for the selected capture mode appears in the
upper left on your camera status screen.
2. Press the Shutter/Select button [
countdown and the camera status lights flash each time a photo
is captured.
3. To stop capturing, press the Shutter/Select button [
camera status lights flash three times and the camera beeps
three times.
PRO TIP: When the camera is off and QuikCapture is enabled, you
can turn the camera on and immediately begin capturing Time Lapse
photos just by pressing and holding the Shutter/Select button [
Press again to stop recording and power off the camera. For details,
see Setup Mode.
42
] repeatedly until you get
] to open the settings menu.
] repeatedly until you get
] to close the settings
]. The camera initiates
]. The
].