Black & Decker BESTE625 Mode D'emploi page 6

ENGLISH
This machine is not to be used as a

toy.
Only use the machine in daylight or

good artificial light.
If the machine starts to vibrate

abnormally or if you hit a foreign
object, switch the appliance off and
remove the plug from the socket.
Check for any damage to the
appliance, replace or repair any
damaged parts, check for and tighten
any loose parts.
Avoid using the machine in bad

weather conditions especially when
there is a risk of lightning.
Use in a dry location only. Do not allow

the machine to become wet.
Do not immerse the machine in water.

Do not open the body casing. There

are not user-serviceable parts inside.
Do not operate the machine in

explosive atmospheres, such as in the
presence of flammable liquids, gases
or dust.
To reduce the risk of damage to

plugs or cords, never pull the cable to
remove the plug from a socket.
Safety of others
Never allow children, persons with

reduced physical, sensory or mental
capabilities or lack of experience and
knowledge or people unfamiliar with
these instructions to use the machine,
local regulations may restrict the age
of the operator.
Children shall not play with the

machine.
6
(Original instructions)
Cleaning and user maintenance shall

not be made by children without
supervision.
Residual risks
Additional residual risks may arise when
using the tool which may not be included
in the enclosed safety warnings. These
risks can arise from misuse, prolonged
use etc.
Even with the application of the
relevant safety regulations and the
implementation of safety devices, certain
residual risks can not be avoided. These
include:
Injuries caused by touching any

rotating/moving parts.
Injuries caused when changing any

parts, blades or accessories.
Injuries caused by prolonged use of a

tool.
When using any tool for prolonged
periods ensure you take regular
breaks.
Impairment of hearing.

Health hazards caused by breathing

dust developed when using your
tool (example:- working with wood,
especially oak, beech and MDF).
Vibration
The declared vibration emission values
stated in the technical data and the
declaration of conformity have been
measured in accordance with a standard
test method provided by EN50636 and
may be used for comparing one tool with
another.