Storing And Transporting; Cleaning And Storing - easymaxx 06918 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN

Storing and transporting

The SUP board must be folded together so that it has a maximum width of the bag (about
35 cm). Make sure that it is not bent too strongly. Also make sure that the anti-slip cover
mat is folded inwards to protect the surface.
1. Start at the bow of the SUP board (Picture F1) so that any possibly remaining air can
escape through the valve on the stern as it is folded together.
2. Fold the SUP board together until it has the width of the carrier bag.
3. Make sure that the stern part is folded inside instead of over the rest of the folded
SUP board, because otherwise the large fi n box will be in the way when folding (Pic-
ture F2).
4. Place the belt around the SUP board and tighten it. In this way, the SUP board re-
mains fi xed in the folded state.
5. Place the SUP board in the carrier bag (Picture F3).
Be sure the SUP board is dry before it is stored. If it is stored while wet, it should
be unpacked and completely dried and repacked as soon as possible to avoid
mould.
6. Also store the fi ns, leash and repair kit in the carrier bag and then zip it closed.
The remaining accessories can also be put into the carrier bag (Picture F4).
7. Remove the lower part of the paddle and put both parts in the paddle pocket on the
carrier bag. Use the strap with the plug-in fastener to fasten.
8. Put the air pump in the carrier bag loops and use the strap with the plug-in fastener
to fasten. Make sure that the hose is also fastened or remove it and store it in the
carrier bag.

Cleaning and storing

PLEASE NOTE!
Do not use any corrosive or abrasive cleaning agents or cleaning pads. This might
damage the surfaces.
Routinely rinse the SUP board, fi ns and paddle with clear water. With chunkier soil-
ing, a mild cleaning agent can be used.
Wipe down the leash, the carrier bag and the air pump with a damp cloth if necessary.
Allow all parts to dry completely before the SUP board is reassembled and / or stored
away.
Store the SUP board and all accessory parts in a dry, clean, frost-free place that is not
accessible to children and animals.
For longer storage periods, it is recommended that the SUP board is only rolled up
loosely or completely unfolded so that no strong creases occur which could damage
the material in the long term.
06918_DE-EN-FR-NL_A5_V1.indb 18
06918_DE-EN-FR-NL_A5_V1.indb 18
18
29.11.2019 09:54:49
29.11.2019 09:54:49

Publicité

Table des Matières
loading

Table des Matières