Infl Ate; Inserting / Removing The Fi N; Attaching The Leash - easymaxx 06918 Mode D'emploi

EN
Infl ate
1. Remove the SUP board from the carrier bag and spread it out on a smooth surface
that is free of sharp or pointed objects.
2. Put the air pump hose on the connector (Picture B) and twist clockwise to secure.
3. Unscrew the protective cap on the stern of the SUP board, put the hose on the valve,
push down and twist clockwise to secure (Picture C). The bayonet adapter must be
correctly seated in the valve.
4. Place the air pump on solid, even ground and fi x at the foot part with the feet.
NOTICE – Pressure that is too high can cause material damages! Do not use an air
compressor. The maximum air pressure for this SUP board is 15 psi / 1 bar. Never pump
over 15 psi / 1 bar!
5. Grab the handle and pump air into the SUP board by moving the handle up and down.
The higher the pressure in the SUP board, the more diffi cult it will be to pull the
handle of the pump. In this case, open the bridge opening. Now, air will only pump
into the board when the handle is pushed downwards, but it will be easier to bring
the handle back upwards.
6. Once the SUP board is completely infl ated, unscrew the bayonet adapter from the valve.
7. If the valve pin doesn't turn back into the proper position and air begins to escape,
turn the pin a bit until the spring comes up. Now the valve is closed. It is possible, in
this case, that it will need a little more air.
8. Place the protective cover back on the valve and screw shut.
Inserting / removing the fi n
When replacing the fi n, make sure that the tip of the fi n is pointing downwards.
1. Place the SUP board so that the small fi ns are facing upwards.
2. Push the large fi n directly into the guide of the fi n box (Picture D1) until it is fully
seated in the rail.
3. The fi n must be anchored with the locking pin (Picture D2). To do this, put it into the
opening until it audibly clicks into place.
To remove the large fi n, remove the locking pin by lightly pushing down and then pulling
out, and then push the fi n out of the rail.

Attaching the leash

Never use the SUP board without having one leash on board and a foot loop attached
to the user! In some countries, this is a law - fi nd out what the local regulations are and
observe them!
• Pull the fabric band on the leash through the ring on the stern of the SUP board and
attach the leash.
• Place the foot loop around the ankle and fi x it using the hook and loop fastener strap.
06918_DE-EN-FR-NL_A5_V1.indb 16 06918_DE-EN-FR-NL_A5_V1.indb 16
16
29.11.2019 09:54:48 29.11.2019 09:54:48