Shutting Down; Maintenance And Care - Windsor Treadway Instructions

Moving the appliance to the side
Set the appliance switch to 'dry vacuum
cleaning' position. Dry vacuum cleaning
is activated.
Let the pump pressure fall to 0 bar.
Set the appliance switch to "0".
Release the foot pedal.
Press pedal for raising the brush head.
Brush head is raised.
Move the appliance to the side.
Press pedal for lowering the brush head.
Brush head is lowered.
Press the foot pedal and place the ma-
chine centrally in the ridges of the steps.
Set the appliance switch to regular or ba-
sic cleaning.
Then clean using clear water so as to re-
move detergent residues.
Danger
Risk of injury! To refill detergent, always
move out the machine first from the working
position.

Shutting down

Complete cleaning
Set the appliance switch to 'dry vacuum
cleaning' position. Dry vacuum cleaning
is activated.
Let the pump pressure fall to 0 bar.
Set the appliance switch to "0".
Release the foot pedal.
Press pedal for raising the brush head.
Brush head is raised.
Release the rear wheels.
Drive out the machine from the working
position and the podium until it is on firm
ground.
12
English
Turn off device
Pull out the electrical plug.
Drain off and dispose of the remaining
detergent fluid.
Drain out the dirty water and dispose it
off.
Clean the inside and outside of the ma-
chine. Rinse the tanks with clear water.
Store the machine in a frost-free room on
an even and clean floor.
Lock the rear wheels.
Remove the cordon from the travellator/
escalator only when the entire working
area is dry again. There is risk of acci-
dent on account of slipping even if the
travellator/ escalator is slightly moist.

Maintenance and care

Danger
Risk of injury! Before doing any work on the
machine:
Set the appliance switch to "0".
Pull out the electrical plug.
Lock the rear wheels.
Drain off and dispose of the remaining
detergent fluid.
Drain out the dirty water and dispose it
off.