Waterpik WF-10 Serie Mode D'emploi page 7

Pressure
Setting
Remove
Adjusting the Pressure Setting
· First press (from OFF) starts unit on "LOW".
· Second press turns unit to "HIGH".
· Third press turns unit "OFF".
The single LED exhibits the following behavior:
· Solid - If motor is running and battery is greater than half full.
· Single blink every 2 seconds - When charger is connected and battery is fully charged.
Recommended Technique
Lean low over sink and place tip in mouth. Aim the tip toward gumline, and turn the unit ON (I).
For best results, start with the back teeth and work toward the front teeth. Glide tip along gumline and pause briefly between teeth.
Continue until you have cleaned the inside and outside of both the upper and lower teeth.
Direct the jet stream at a 90-degree angle to your gumline. Slightly close lips to avoid splashing but allow water to flow freely from
mouth into the sink. Keep unit upright during use for best results.
When Finished
Turn the unit OFF. Empty any liquid left in the reservoir.
If desired, the reservoir may be removed from the power handle by simply pulling down on the reservoir to remove.
7