Reverse Function - Rexel Auto+ 500X Manuel D'utilisation

Operation
After unpacking the product pull out the shredder bag frame
1
and remove the CD shard tray, which sits on top of the bag
frame. Store this tray on the product as shown and use
when you shred CDs (see fig 1).
Lift up the loading door (E) and open oil flap (V).
2
Remove oil cap and fill up the reservoir using the 30ml
3
bottle of oil provided. Replace the cap.
Connect the shredder to mains supply.
4
Check that the on/off switch at the back of the machine is
5
switched to the 'ON' position.
Press and hold down the Auto button (
6
to start the pump and prime the system. Only required
when the product is used for the first time.
To load the shredder, simply lift the loading door handle (see
7
fig 5) to open the loading door and insert documents. You
can open the door further to 90 degrees for easier access
if required Load up to 500 sheets at a time into the feed
chamber (see fig 2).
Do not fill above the MAX level, this could damage the
shredder (see fig 3).
The shredder will start the shredding cycle automatically
8
ONLY after closing the loading door (see fig 2).
Attention: If required you can now lock the loading door by
entering a 4 digit code (see below).
If you only have up to 10 sheets to shred, you can use the
9
manual feed slot, provided the auto feed chamber is empty
(see fig 4).
Insert paper to be shredded into the feed area. The
J
shredder will detect the paper and start automatically.
If the shredder is left in auto mode for more than 2 minutes
K
without being used, the shredder will automatically turn back to
standby mode in order to save power.
The shredder will automatically 'wake up' from sleep mode
L
when paper is inserted into the shred mouth or you open
the loading door. There is no need to press the Auto button
( ).

Reverse Function

Should you wish to reverse paper out whilst shredding, a
1
reverse button (
Reverse the paper out then turn the machine off using the
2
ON/OFF switch at the rear of the shredder. Remove the
paper from the manual feed slot (if being used) or open the
loading door, remove the remaining stack of paper, then pull
the jammed paper free of the cutting mechanism.
To resume shredding return the slide switch to the auto
3
position (
OFF switch at the rear of the shredder.
) for 5 seconds
Locking the Paper Loading Door
For additional security the paper loading door can be locked
during the shredding of confidential material.
To lock shredder:
1 Place documents in tray. Close paper loading door (see fig 2).
2 Press any 4 digits. REMEMBER YOUR CODE!
Shredder unlocks automatically when:
• 4 digit code is re-entered.
• Shredding is complete.
• Shredder is inactive for 30 minutes (but documents remain
in tray)
CD Shredding
A separate CD tray is provided to collect the shredded CD
shards. Ensure that this is correctly mounted onto the standard
shredder bag frame before shredding (see fig 7).
Lift up the paper loading door (see fig 5).
1
Always insert CDs in the CD slot (see fig 6). Only shred one
2
CD at a time.
Close the paper loading door (see fig 2).
3
Empty the CD bin after 8 CDs to avoid waste spilling over
4
into the paper waste bin.
Remove the CD tray before recommencing to shred paper
5
and store on the side of the shredder (see fig 7).
G
) has been fitted for your convenience.
) and turn on the shredder by using the ON/
7