Olimpia splendid CALDO UP T Instructions Pour L'installation, L'emploi Et L'entretien page 47

If the set temperature is slightly higher than the ambient one (+1÷2°C), the minimum
power heating function activates automatically (FAN and LOW LEDs turned on).
If the set temperature is greatly higher than the ambient one (>3°C), the maximum pow-
er heating function activates automatically (FAN and HIGH LEDs turned on).
If the set temperature is lower than the ambient one, the fan function activates automat-
ically (FAN LED turned on).
The set temperature can be changed at any moment during functioning.
9.5 - Switching off delay mode
Press button
off delay mode; the TIMER LED on the appliance display turns on and the value
is shown.
Press the button once or more to set the desired delay (from 1 to 8 hours) after
which the unit will turn off.
Wait approximately 5 seconds without pressing any button: the delay will be set and the
TIMER LED will turn on on the display.
After confirming the activation of the timer, it is possible to change the functioning mode
at any moment by pressing button
switch to stand-by mode.
To cancel the delayed switching off, press button
by mode or, as an alternatively, repeat the setting procedure of the delay, entering the
value .
It is possible to set the desired delay until the hours numeric sym-
bol flashes. Once setting is over, after 5 seconds, the numeric val-
ue stop flashing and it is automatically memorized. Is it's desired
to further change the delay time, it's necessary to repeat the oper-
ation from the beginning.
If the weekly timer is set, it's not possible to set this function.
when the appliance is functioning to activate and set the switching
. Once the set time has passed, the unit will
and the unit will switch to stand-
EN - 19
CALDO UP T