Olimpia splendid CALDO UP T Instructions Pour L'installation, L'emploi Et L'entretien page 33

Disassembly, repair or remodelling by an unauthorized person may
result in serious harm and will void the manufactures warranty.
Before connecting, make sure that the plate data corresponds
with the mains electrical supply.
The plate (W) is located on the back of the appliance (figure A).
Install it according to the manufacturer's instructions An incorrect
installation can cause damage to people, animals or property for
which the manufacturer accepts no responsibility.
• Always and only use it in a horizontal position.
• Position it, so that the air flow, both inlet and outlet, is free of obstacles.
If the power cord is damaged, it must be replaced by the
manufacturer, his technical service or a similarly qualified person
in order to eliminate all possible risks.
Install it in such a way that the switches and other controls cannot
be reached by persons using the bath or shower.
• Do not use extensions.
• Keep all objects at least 1.5 meter from the front, sides and rear of the
appliance.
• Do not place appliance close to a radiant heat source.
• Do not operate in areas where gasoline, paint or other flammable liquids
are used or stored.
• Do not use the appliance to dry clothes.
Do not insert or allow foreign objects to enter any ventilation
or exhaust opening, as this may cause an electric shock, fire or
damage to the appliance.
• This appliance is intended for household use only
not for commercial or industrial use.
Use this appliance only as described in this manual.
Any other use is not recommended by the manufacturer and may
cause fire, electric shock or injury.
;
EN - 5
CALDO UP T