Hikmicro G Serie Mode D'emploi page 9

● When the device is powered off and the RTC battery is full, the time settings can be kept
for 15 days.
● In the first use, power on the device and charge the RTC battery with the lithium battery for
more than 10 hours.
● The battery voltage is 3.6 V, and the battery capacity is 6700 mAh.
● The battery is certified by UL2054.
Maintenance
● If the product does not work properly, please contact your dealer or the nearest service center. We shall not
assume any responsibility for problems caused by unauthorized repair or maintenance.
● A few device components (e.g., electrolytic capacitor) require regular replacement. The average lifespan
varies, so periodic checking is recommended. Contact your dealer for details.
● Wipe the device gently with a clean cloth and a small quantity of ethanol, if necessary.
● If the equipment is used in a manner not specified by the manufacturer, the protection provided by the
device may be impaired.
● We recommend you send the device back for calibration once a year, and please contact the local dealer for
the information on maintenance points.
● Please notice that the current limit of USB 3.0 PowerShare port may vary with the PC brand, which is likely to
result in incompatibility issue. Therefore it's advised to use regular USB 3.0 or USB 2.0 port if the USB device
fails to be recognized by PC via USB 3.0 PowerShare port.
Using Environment
● DO NOT expose the device to extremely hot, cold, dusty, corrosive, saline-alkali, or damp environments. Make
sure the running environment meets the requirement of the device. The operating temperature shall be
-20 °C to 50 °C (-4 °F to 122 °F), and the operating humidity shall be 90% or less.
● This device can only be safely used in the region below 2000 meters above the sea level.
● Place the device in a dry and well-ventilated environment.
● DO NOT expose the device to high electromagnetic radiation or dusty environments.
● DO NOT aim the lens at the sun or any other bright light.
● When any laser equipment is in use, make sure that the device lens is not exposed to the laser beam, or it
may burn out.
● The device is suitable for indoor and outdoor uses, but do not expose it in wet conditions.
● The level of protection is IP 54.
● The pollution degree is 2.
Technical Support
● The https://www.hikmicrotech.com portal will help you as a HIKMICRO customer to get the most out of your
HIKMICRO products. The portal gives you access to our support team, software and documentation, service
contacts, etc.
Emergency
● If smoke, odor, or noise arises from the device, immediately turn off the power, unplug the power cable, and
contact the service center.
7