EGO PTX5100 Guide D'utilisation page 16

DETACHING THE ATTACHMENT FROM THE TELESCOPIC POWER POLE
1. Switch off the tool and remove the battery pack.
2. Loosen the locking knob.
3. Press the shaft-release button and, with the button depressed, pull the hedge
trimmer attachment out of the coupler to detach it from the telescopic power
pole.
MOUNTING THE TIP PROTECTOR (Available separately)
1. Use a hex wrench (not included) to remove the short bolt, plain washer, bushing
and nut at the end of the blade (Fig. 5). Save the plain washer, bushing and nut for
reassembly.
2. Align the tip protector with the bulge on the blade and mount it into place. Secure
it with the new long bolt and nut as well as the saved washer, bushing and nut
(Fig. 6).
5
16
HEDGE TRIMMER ATTACHMENT — PTX5100/PTX5100-FC
Nut
Bushing
Plain Washer
Short Bolt
6
Bulge on the
blade
Nut
Tip Protector
Nut
Bushing
Plain Washer
Long Bolt