Using The Device - Dometic MO 8952 Notice D'utilisation

Using the device

6.2 Connecting the device to the power supply
1. Connect the device as shown (fig. 5, page 5).
2. Add a 1 A fuse in the plus line near the battery.
7 Using the device
7.1 Igniting a burner
!
WARNING! Risk of injury
The complete ignition process must be visible from above and must not
be hidden by pots placed on the stove.
A
NOTICE!
The flame must not extend beyond the edge of the pot. Centre the pot
above the burner ensuring stability on the pot grid (see page 3).
1. Only use pots with a diameter of 16 to 22 cm.
2. Ignite a burner as shown (fig. 6, page 6).
7.2 Switching off the device
➤ Switch off the device as shown (fig. 7, page 7).
7.3 Replacing the gas cylinder
!
WARNING! Risk of injury
Only replace the gas cylinder when there is good ventilation.
Make sure that there is no source of ignition nearby.
Only change the gas cylinder when the device is not in use and the gas
supply to the device is switched off.
1. Switch the device off by turning the knob to the zero setting.
2. Close the valve on the gas cylinder.
3. Replace the gas cylinder according to the instructions from the gas fitting
manufacturer.
16
Hobs and Combinations
EN