Module Assembly - General - Sulfurcell SCG-HV-F Instructions D'installation

moDulE aSSEmBly – GENERal
Knowledge of and adherence to
the relevant standards and regu-
lations on application and mounting of
solar modules is necessary for proper
mounting of the solar modules. Such
regulations mainly include the corre-
sponding DIN standards, VDE and
VDEW guidelines. Improper mounting
may not only damage or destruct the
solar module, but may also cause per-
sonal injuries and material damages.
PV modules must be handled
!
with care while they are being
installed. Knocks on front and rear
sides or corners and edges can dam-
age the module. Damaged modules
must not be used.
The modules must be mounted without
torsion (warping).
Cross-ties, screws and other fastening
elements must be commercially avail-
able and meet the DIN 1055 standard.
In particular, the fastening elements
must be equipped for the easterly wind
and snow forces in accordance with
DIN 1055-4 and 1055-5.
The modules must be fastened in such
a way that melting water and rain
water can flow out freely and the
PV module is not wet for sustained
periods.
Position the solar modules at an angle
of at least 3° to the horizontal.
When mounting the unit vertically to
the slope direction, ensure that the
junction box is positioned at the top.
EN