JUKI MO-50e Manuel D'instructions page 12

Preparing the machine
Attaching the foot control
B
Plug foot control into machine
socket (A) and then into main
socket (B).
A
Sewing speed
The sewing speed can be
adjusted by increasing or
decreasing the pressure on the
foot control (C).
Assembling the thread stand
Raise the support rod fully,
turning slightly until the
positioning catches engage.
Thread cones
The anti-vibration cone should
be used with the wider edge to the
bottom on the spool holder
pin when sewing with cones.
When using household spools
remove the anti-vibration cones.
Place spool on spool holder pins
and push the spool caps on.
If threads slip and get twisted,
cover the spools with the nets
supplied in the accessory box.
OFF
Power/light switch
O
ON
The power switch is conveniently
I
placed on the handwheel side of
the machine.
"I" - ON
"O"-OFF