Setting The Torque - Hilti SFE 2-A12 Notice D'utilisation Originale

5.4 Fitting the adapter
Other adapters can be fitted additionally onto the right-angle adapter.
1. Insert the adapter into the chuck.
▶ The adapter snaps into engagement.
2. Check correct installation.
5.5 Removing the adapter
1. Pull the locking sleeve and hold it in this position.
2. Remove the adapter.
5.6 Inserting bits (hex bit holders)
The hex bit holders of the eccentric adapter and the right-angle adapter
hold the bit magnetically.
1. Pull the locking sleeve and hold it in this position.
2. Insert the bit.
3. Release the locking sleeve.
5.7 Inserting drill bit (keyless chuck)
1. Open the keyless chuck.
2. Insert the drill bit.
3. Close the keyless chuck.
6 Operation
Observe the safety instructions and warnings in this documentation and on
the product.
6.1 Selecting the gear
▶ Operate the gear selector switch.

6.2 Setting the torque

The torque is limited only when the power tool is set to screwdriving
mode .
▶ Turn the adjusting ring to the desired torque setting.
*2236949*
4
3
2236949 English 11