Publicité
Les langues disponibles
Les langues disponibles
FILLING UNIT WITH WATER
CAUTIONS:
When filling, do not allow water to spill onto controls. Never
add essential oils in the water. It can damage the plastic seals
and cause leaks.
Do not use the vapor outlet on the water tank as a handle. It is
not designed to support the water tank when full. Always hold
the full water tank in two hands.
Once the water tank is filled and placed on the base, do not
attempt to move the humidifier. Leakage will occur.
1.
Remove and set aside vapor nozzle.
2.
Lift water tank off base and turn it upside down.
3.
Remove the water cap.
4.
Holding the tank carefully in two hands, fill the water tank
with fresh cool water.
5.
Wipe any spilled water from exterior of tank and
screw water cap back onto tank. Verify cap is tightly in-
stalled back onto water tank before replacing it onto base.
NOTE:
The water tank and base only go together one way: Align the logo
on the tank with the center of the knob on the
6.
Replace the water tank by carefully aligning the water tank
and base.
OPTIONAL DEMINERALIZATION CARTRIDGE
(SOLD SEPARATELY)
To install the optional demineralization cartridge, (PN AU500)
follow these instructions.
7.
Perform steps 1-3 above.
8.
Screw cartridge onto cap, being careful not to cross
thread which could cause leakage.
NOTE: Do not fill tank to the brim, the cartridge top will displace
some water.
9.
Replace water cap onto tank and reassemble unit.
base.
5
1.
3.
5.
2.
4.
6.
Publicité
