Table des Matières
Publicité
3
2
1
Four Screws
Quatre vis
Cuatro Tornillos
➢ Remove nozzle hose from body by
(1) pressing in locking tab and (2)
sliding up and out of retaining slot.
➢ Inspect inlet of nozzle hose and
clear any obstructions.
➢ Replace nozzle hose by sliding
down on retaining bracket until you
hear a click.
➢ Return the vacuum cleaner to the
upright position before plugging
into an electrical outlet.
Replacing Belt
➢ Replace belt whenever a burning
rubber smell caused by excessive
slippage occurs.
➢ Turn off and unplug the vacuum
cleaner.
➢ Lay unit on floor bottom up with
nozzle flat.
➢ Remove nozzle hose from body by
(1) pressing in locking tab and (2)
sliding up and out of retaining slot
(see REMOVING CLOGS, p. 40).
➢ Remove the four screws from the
nozzle cover. Next place the
vacuum in the upright position
standing on the handle. This will
minimize wheel interference when
removing nozzle bottom plate.
Remove nozzle bottom plate by
rotating upward.
Motor shaft may be hot.
- 42 -
CAUTION
Publicité
Table des Matières
