Replacing Belt - Panasonic MC-UG775 Manuel D'utilisation

Lift Agitator Up
Soulever l'agitateur
Unidad del agitador
Motor Shaft
Arbre d'entraînement
du moteur
Eje del motor
Slide Arch
Arc glissant
Aarco deslizante
End Cap
Bouchon
Tapa de
extremo
Groove
Ouverture
Ranura
Slide Arch
Arc glissant
Aarco deslizante

Replacing Belt

Groove
Ouverture
Ranura
- 34 -
➢ ➢ Replace belt whenever a burning
rubber smell caused by excessive
belt slippage occurs.
➢ ➢ Remove lower plate. See: "Removing
and Installing Lower Plate"
➢ ➢ Remove agitator by carefully lifting
out.
➢ ➢ Remove worn or broken belt.
➢ ➢ Clean agitator. See: "Cleaning
Agitator"
➢ ➢ Loop new belt (Panasonic Type UB8
only) around motor shaft and
agitator pulley; see illustration for
correct belt routing.
➢ ➢ Reinstall slide arch into the agitator
end cap.
➢ ➢ Reinstall agitator back into nozzle
housing grooves.
➢ ➢ After reinstalling the agitator, turn it
by hand to make sure the belt is not
twisted or pinched and that all
rotating parts turn freely.
➢ ➢ Reinstall lower plate. See: "Removing
and Installing Lower Plate"