Installation; Wall Mounting - Bosch ICM Notice D'installation

3

Installation

3.1 Installation
DANGER: Risk of electric shock!
B Before connecting the power supply,
interrupt the power supply to the boilers
and to all other BUS subscribers.
B Disconnect the emergency shutoff switch
on the appliance or outside the boiler
room, or disengage the heating system
circuit breaker.
3.1.1

Wall mounting

B Determine the location on the wall in accordance with
the dimensions of the ICM module.
B Determine whether there is sufficient room below the
ICM to run conduit for line voltage to all required
components.
B Undo 2 screws at the bottom of the ICM module, pull
the cover at the bottom forward and lift off upwards
( fig. 7).
Fig. 7 Removing the cover
B For the upper attachment screw, drill a Ø 1/4" (6 mm)
hole, insert an appropriate wall anchor, and insert the
screw until only 1/16" (1.5 mm) protrudes (
1
/ 1
6
"
( 1
3.
, 5
m
m
)
1.
4.
6 720 617 648-02.1O
Fig. 8 Upper attachment screw
B Punch out the prepared slots at the back panel of the
ICM module for the lower attachment screws.
B Engage the ICM module with the top attachment
screw.
B Mark the holes to be drilled on the wall through the
breakouts created.
B Remove the ICM module.
Installation | 11
fig. 8).
2.
4.
3,5 mm
1/4"
1/4"
6 720 643 835 (2011/06)