How To Connect The Electronic Flash; Connecting The Underwater Optical Fiber Cable - Olympus PT-EP01 Mode D'emploi

4. How to connect the electronic flash

Connecting the underwater optical fiber cable

To connect the UFL-2 underwater flash (optional) to the Case using an underwater optical fiber cable
(optional: PTCB-E02), follow the procedures below.
How to connect the underwater optical fiber
cable
1 Remove the cap of the optical fiber cable
insertion slot.
2 Put the underwater optical fiber cable plug all the
way into the optical fiber cable insertion slot.
Setting of the digital camera
1 Set the RC mode of the camera to ON so that the camera's built-in flash is activated.
2 Load the camera in the Case with the camera's built-in flash popped up.
In case of UFL-2, turn the RC mode to OFF.
For details, refer to the instruction manual of UFL-2.
In case of UFL-1, turn the RC mode to OFF.
En
EN 15