Safety Regulations For Finecoat Spraying - WAGNER FineCoat Power Cart Mode D'emploi

Safety Regulations for FineCoat Spraying

All local regulations in force must be observed.
In order to ensure safe operation of the FineCoat systems
the safety regulations listed below must be followed.
1. Read the operating manual carefully and follow the
instructions given in order to avoid possible danger.
2. Only coating materials with a flash point of 21 °C or
over may be sprayed, without additionalheating.
3. Use of this unit is prohibited in workshops whichcome
under explosion prevention ordinances.
4. Never operate near sources of ignition, e.g., open
flames, cigarettes, cigars and pipes, sparks, red hot
wires, hot surfaces, etc.
5. Warning! Risk of injury by injection!
Never point the spray gun at persons or animals
6. Always wear a protective mask when spraying. In
order to avoid occupational illnesses, always follow the
manufacturer's instructions for the materials, solvents and
cleaning agents used when preparing and using such
materials and when cleaning the unit. Protective clothing,
gloves and, if necessary, skin protection cream should be
used to protect the skin.
7. Depending on the flow speed, an electrostatic charge
can, in certain cases, build up on the unit. This could
give rise to sparks and flames on discharging. It is,
therefore, necessary that the unit is earthed over the
electrical installation. The connection must be made with a
shockproof socket earthed conforming to specification.
8. For safety reasons, never use solvents based on 1,1,1
trichloroethane or methylene chloride.
9. Caution: When operating the FineCoat system indoors
or outdoors, make sure that no solvent vapors are
carried towards the turbo-blower and that no solvent
containing vapors can accumulate in the near the
turbo-blower.
Position the turbo-blower on the opposite side to the
object to be sprayed. Check the wind direction when
spraying outdoors. When working indoors, a sufficient
flow of air must be ensured for extracting the solvent
vapors.
A minimum distance of 3 m must be maintained
between the turbo-blower and the object being
sprayed.
GB
10. Extraction systems should be installed on-site in
accordance with local regulations.
11. The work-pieces to be sprayed must be earthed.
12. For breaks in work always secure the spray gun
against unintentional operation.
13. Caution: never open the pressure tank during
operation, but only after releasing the operating
pressure! Check the pressure gauge display.
14. When cleaning the unit with solvents, never spray into a
container with only a small opening (bunghole). Formation
of a explosive gas/air mixture can occur. The container
must be earthed.
15. When transporting the system, it must be suitably secured
for the particular means of transport.
16. Always remove the mains plug from the socket before
carrying out any work on electrical components.
17. Work or repairs to the electrical fittings must be carried out
by a specialist electrician. This is also valid even if there
are references to such work in the operating manual. No
liability will be accepted for improper installation.
18. Positioning on uneven ground
The front part of the unit must point downwards, to prevent
the unit from slipping away.
13