Ordinary Operations - WamBlee W880 Manuel D'instruction

6

Ordinary operations

6.1 First installation
EN
• Remove the boa radio from the packaging (Fig. 1).
• Remove the antenna from the packaging (Fig. 2).
Install the antenna on the boa radio, screwing the spring base of
•
the same antenna above the steel bracket to the top of the boa
radio (fig.4). The mounting of the antenna is done without the use
of mechanical equipment and the seal of the antenna is
guaranteed by the special feature of the coupling of the spring.
6.2 Charge the battery
• Place the W880 boa radio on the W890 battery charger (Figure 3)
(use the battery charger for service and maintenance manuals).
• The full charge will be in 6 hours
6.3 Installation on the longline
• The W880 Arrow Radio is designed for use with its counterweight /
float system, which is also the Boa Activator.
• Prepare a mechanical connection between the counterweight of
the W880 boom and the track. Warning: The W880 boom radio
float is designed to support the weight of the boa radio and not
the way. In general, the counterweight is connected by means of
a top equipped with a ballast placed at the base of the same
counterweight. The ballast must be determined when the
counterweight is positioned so that the sea level is half the float
(approximately 4 to 6 kg) (Figure 5).
• If the float is deflated, turn it with a small compressor and, when
inflated, close the valve inlet with the cap (fig.6). M aximum
inflation pressure = 0.15 Bar
• Insert the boom radio into the counterweight seat (fig 8).
• Turn the boom radio until it is inserted into the base (insertion
26