Setting The Clock - Sharp SD-SG11 Mode D'emploi

Setting the Clock

In this example, the clock is set for 9:30 AM on August 15, 2001.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TIMER/DELETE button.
3
Within 10 seconds, press the REC LEVEL/CURSOR or button to
select the "TIME ADJUST".
4
Within 10 seconds, press the ENTER button.
5
Press the REC LEVEL/CURSOR
and then press the ENTER button.
6
Press the REC LEVEL/CURSOR
and then press the ENTER button.
7
8




9




To confirm the time display:
[When the unit is in the stand-by mode]
Press the DISPLAY button on the remote control.
The time display will appear for about 5 seconds.
[When the power is on]
Press the TIMER/DELETE button.
or button to adjust the year,
Within 10 seconds, press the REC LEVEL/CURSOR
The time display will appear for about 10 seconds.
Note:
The clock setting will be cleared when the unit is unplugged or the power failure
occurs.
or button to adjust the month,
To reset the clock:
Perform "Setting the Clock" from the beginning.
Press the REC LEVEL/CURSOR or
and then press the ENTER button.
Press the REC LEVEL/CURSOR or
and then press the ENTER button.
The 12-hour display will appear.
AM 12:00 is 12 o'clock midnight.
PM 12:00 is 12 o'clock noon.
"AM" will change to "PM" automatically.
Press the REC LEVEL/CURSOR or button to adjust the minutes,
and then press the ENTER button.
The hour will not advance even if minutes advance from "59" to "00".
The clock starts from "0" second. (Seconds are not displayed.) The time display
will disappear after a few seconds.
01/7/13 01-14.fm
SD-SG11
button to adjust the date,
button to adjust the hour,
or button.
E-14
E
F