Remote Control - Sharp SD-SG11 Mode D'emploi

Remote Control

Battery installation
1
Open the battery cover.
2
Insert the supplied batteries according to the direction indicated in
the battery compartment.


When inserting or removing the batteries, push them toward .
3
Close the battery cover.
Precautions for battery use:


Replace all old batteries with new ones at the same time.


Do not mix old and new batteries.


Remove the batteries if the unit will not be used for long periods of time. This will
prevent potential damage due to battery leakage.
Caution:


Do not use rechargeable batteries (nickel-cadmium battery, etc.).


Installing the batteries incorrectly may cause the unit to malfunction.
Notes concerning use:


Replace the batteries if the operating distance is reduced or if the operation
becomes erratic. Purchase 2 "AAA" size batteries (UM-4, R03, HP-16 or similar).


Periodically clean the transmitter on the remote control and the sensor on the ste-
reo system with a soft cloth.


Exposing the sensor on the stereo system to strong light may interfere with opera-
tion. Change the lighting or the direction of the stereo system.


Keep the remote control away from moisture, heat, shock, and vibrations.

Test of the remote control
Check the remote control after checking all connections have been made correctly.
(See pages 9 - 11.)
Face the remote control directly to the remote sensor on the unit.
The remote control can be used within the range shown below:
Press the ON/STAND-BY button. Does the power turn on? Now, you can enjoy your
system.
Remote sensor
01/7/12 01-14.fm
SD-SG11
8" - 20'
(0.2 m - 6 m)
15˚
15˚
E-8
E
F