Publicité
Les langues disponibles
Les langues disponibles
GB
5.
Align the ascending tube. (Fig. 5)
If the ascending tube is positioned correctly, the container contents can be sprayed
without almost any residue. When working on lying objects: Turn the ascending
tube forwards. (Fig. 5A)
Spraying work when working on overhead objects: Turn the ascending tube
rearwards. (Fig. 5B)
6.
Place the container on a paper base and fill in the prepared coating material.
Screw the container firmly onto the spray attachment.
7.
Connect the front part of the gun and the gun handle to each other. (Fig. 6)
8.
Close the device cover and pull the carry handle upwards. This makes the gun holder
accessible.
9.
Put the spray gun onto the gun holder at the device.
10.
Place the device only on a plane and clean surface. Otherwise, the gun may suck in
dust, etc.
11.
Switch on the main switch at the device (Fig. 1, item 14).
12.
Remove the spray gun from the gun holder and point it at the object to be coated.
ATTENTION: It is advisable to test spray cardboard or a similar material
13.
Press the On/Off switch at the gun handle (Fig. 7, item 2).
Three different spray jet settings can be chosen on the spray gun, depending on
the application and target object.
Selecting the Spray Setting
Fig. 8 A = horizontal flat jet
Fig. 8 B = vertical flat jet
Fig. 8 C = circular jet
Adjusting the desired Spray Setting (Fig. 9)
With the union nut (1) slightly unscrewed, turn the air cap (2) to the desired spraysetting
position (arrow). Then tighten the union nut.
WARNING!
Adjusting the Material Volume (Fig. 7, item 3)
Set the material volume by turning the regulator on the trigger guard of the spray gun.
- turn to the left
+ turn to the right
18
in order to determine the material and amount of air for an
optimal spray pattern.
for horizontal surfaces
for vertical surfaces
for corners, edges and hard-to-reach surfaces
Danger of injury! Never pull the trigger guard while adjusting
the air cap.
lower material volume
higher material volume
W 860 E
Publicité
