Honeywell MILLER Twin Turbo G2 Connector Mode D'emploi page 5

4.0 Assembly and
Installation
Refer to referenced pictures in Appendix A
on pages 16-20.
WARNING
When Twin Turbo G2 Connector is prop-
erly installed, harness webbing MUST-
be captured in connector carabiner and
webbing retainer clip.
TABLE 2: Honeywell-Approved Components
For Use with the Twin Turbo G2 Connector
Compatible
Personal Fall Limiters (PFLs)/
Self-Retracting Lifelines (SRLs)
Miller TurboLite Personal Fall Limiters
Miller Turbo T-BAK Personal Fall Limiters
Compatible Harnesses
(without D-Pad Clip)
Miller AirCore Harnesses
Titan T2000, T2007, and T2500 Series Harnesses
Titan T-Flex Stretchable Harnesses
Titan Non-Stretch Harnesses (including T4000, T4007,
T4078, T4500, T4507, and T4577 series)
North Harnesses*
*North Rite-On Harnesses (including the Saf T Climb Harness) are not compatible with the G2 Connector; North Rite-On II
Harnesses are compatible.
4.1 Installing Optional Har-
ness D-Pad Clip to Harness
D-Pad
To install D-pad clip to harness, see
Fig. 3.
• Harness D-pad clip is only compatible
with Miller style harness D-pad shown in
Fig. 2a.
• D-pad clip is optional, but recommended
for best performance to minimize slip-
page of the G2 Connector on the harness
webbing.
• D-pad clip is not necessary for harnesses
with back pads sewn to the harness
webbing (e.g., Miller AirCore Harnesses);
D-pad clip is also not needed for some
Miller D-pads, such as the two examples
shown in Fig. 2b. See section 4.3 for
installation of the G2 Connector without
using the D-pad clip.
To remove D-pad clip from harness,
see Fig. 4.
Compatible Harnesses
(recommended with D-Pad Clip)
Miller Revolution Harnesses (including Construction,
Arc-Rated, Tower Climbing, Derrick/Oil Rig, and Vinyl-
Coated)
Miller DuraFlex Stretchable and Miller DuraFlex ULTRA
Harnesses
Miller DuraFlex Python and Miller DuraFlex Python
ULTRA Harnesses
Miller HP (High Performance) Non-Stretch Harnesses
Miller Standard Non-Stretch Harnesses
Miller Specialty Harnesses (including Concrete Construc-
tion, Oil Rig, ProCraft, and Welding)
5