Festo CMMP Serie Mode D'emploi page 25

Main Sub-
index index
15 x
16 x
17 x
21 x
22 x
25 x
26 x
27 x
28 x
30 x
31 x
32 x
33 x
34 x
35 x
36 x
Festo P.BE-K-CMMP-AS-C20 1010NH English
Error message
Division by zero
Initialiszation fault
Drag error
Fault in offset current
measurement
Fault in PROFIBUS
Invalid device type
Checksum fault
Warning threshold
drag error
Operating time
counter
Internal conversion
fault
2
I t-fault
Intermediate curcuit
Drag error in encoder
emulation
Synchronization fault
in field bus
Protection against
slipping of linear
motor
Parameter fault
Cause/measure
Please contact Technical
Support.
Enlarge fault window,
reduce acceleration
Please contact Technical
Support.
Slave address, bus
termination and cabling
Please contact Technical
Support.
Please contact Technical
Support.
Check parametrizing
Acknowledge fault. If fault
occurs again, contact
technical support.
Please contact Technical
Support.
Mechanic part blocked,
check application.
Please contact Technical
Support.
No synchronization
messages from the master.
Sensor signals are faulty.
Check the installation.
Check user parameter
record.
25