Troubleshooting; Technical Data - Inventum AKO6015ZWA Manuel D'utilisation

Procedure
1. Remove the grease filter.
2. Push the lamp holder (B) down from the inside.
3. Carefully turn the defective lamp (A) clockwise out of the holder.
4. Replace the lamp with a new one.
5. Turn the new lamp counterclockwise into the holder.
6. The lamp holder will spring back in position by itself. If this doesn't happen, carefully bend the holder back in
position.
7. Install the grease filter.
8. Repeat the steps for the second lamp.
7

Troubleshooting

GENERAL TROUBLESHOOTING PROCEDURE
1. Try to find a solution for the problem with the help of the troubleshooting table.
2. If you cannot find a solution for the problem, contact the Inventum-servicedienst.
TROUBLESHOOTING TABLE
Problem
The motor does not operate.
The appliance does not operate
correctly or makes an unusual
sound.
8

Technical data

TECHNICAL SPECIFICATIONS OF THE COOKER HOOD
Item
Energy efficiency class
Air flow rate (at min/max speed) [m3/h]
Lighting efficiency class
Grease filtering efficiency class
Noise level at min/max speed [dB]
Color
Possible cause
The mains plug is not connected.
There is no mains supply.
There is a problem with the fuse.
The dimension of the outlet is not
correct.
The outlet has a blockage.
The grease filter is dirty.
The carbon filter is worn.
Specification
D
212/350
A
D
55/65
Black
Possible solution
Connect the mains plug.
• Do a check if the mains plug is
correctly connected to the mains
socket.
• Make sure that the mains supply
is on.
Do a check on the fuse box.
Make sure that you use the correct
dimension during installation. Refer
'Installation'
to chapter .
Remove the blockage.
Clean the grease filter. Refer to
'Cleaning the grease filter'
section
Replace the carbon filter. Refer to
'Replacing the carbon filter
section
(optional)'
.
English
(Figure 15)
.
• 33