Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6
troubleshooting
What to do in case of a malfunction? In most cases, you will be able to correct these faults easily yourself. Please check the solutions
below before contacting the Inventum service department.
The motor is not running
• Is it plugged in correctly?
• Is there a power outage?
• Check the electrical installation.
The performance of the cooker hood is not correct and makes more nois.
• Is the diameter of the exhaust-air pipe correct?
• Is the duct blocked?
• The diameter of the duct must be 120 mm. A smaller diameter can negatively influence the suction of the motor.
• Are the grease filters clean?
• Are the carbon filters not replaced within the last 6 months? Replace the carbon filters.
• Is there enough air supply to replace the extracted air?
7
installation instructions
Read these installation instructions carefully before starting the installation.
Decide whether you install the cooker hood to the wall or under a cupboard and whether there is a duct available or if the cooker
hood needs to recirculte. We advise to install the cooker hood with two persons.
• The minimum distance between the supporting surface for the cooking pans on the cooker and the lowest part of the hood must
be:
- 65 cm for an electric, ceramic or induction cooker
- 75 cm for a gas hob
• If the cooker hood is to be fitted to an existing duct no other aplliances, such as a geyser or heater, may be connected to that same
duct.
• The shorter the duct, and the fewer the bends in it, the better the cooker hood
will work.
• The connection pipe for the cooker hood has a diameter of 120 mm. It is best
also th use a flue pipe of the same diameter.
• Use the provided round cover on the exit you do not want to use.
ELECTRIC CONNECTION
Make sure the supply voltage ratings correspond with those stated on the rating plate. Plug the appliance in. The cooker hood is
provided with a plug. Make sure the plug remains accessible. Place the socket, if necessary, out of sight behind the exhaust-air pipe.
Attention: if you want to make a fixed connection, ensure that a multi-pole switch with a distance between contacts of 3 mm is
installed in the supply cable.
20
•
English
or
Publicité
Table des Matières
