Redmond RI-C244-E Mode D'emploi page 9

Problem Possible cause
Iron produces no
Steam feature is disabled
steam
Not enough water in water tank
Steam output control dial is set
Iron produces very to medium setting
little steam
Anti-drip feature activated
You used water with chemical
additives
Steam coming from
You used distilled or softened
the holes in sole-
water
plate stains fabric
You did not empty the water tank
after last use
Selected temperature is too high
Soleplate is dirty
and stains the fabric
Fabric has not been rinsed suffi-
ciently or you have ironed new
garment before washing it
Selected temperature is too low
Water drips from
Soleplate temperature is too low
holes in soleplate
because you are using Steam
Shot feature too often
You placed the iron on a metal
surface
Soleplate is dam-
Soleplate was damaged by a gar-
aged
ment accessory (zip fastener,
button, rivet, etc.)
V. PRODUCT WARRANTY
Solution
Turn steam output control dial to
We warrant this product to be free from defects for a period of 2 years from the date of
select required steam output
purchase. If the appliance fails to operate properly within the warranty period and is
found to be defective in material or workmanship, we will repair or replace it. This war-
Fill water tank at least ¼ full
ranty comes into force only in case the purchase date can be proved with an original
Turn steam output control dial to
warranty service coupon containing a serial article number and accurate impress of the
increase steam output
company of the seller. This limited warranty does not cover damage caused by the failure
to use this product for its normal purpose or in accordance with the instructions on the
Wait for the soleplate to reach se-
proper use and maintenance of the product, or any kind of repair works. Do not try to disas-
lected temperature (heating indica-
tor goes out) semble the device and keep all package contents. This warranty does not cover normal
wear of the device and its parts (filters, bulbs, non-stick coating, sealing rings, etc.).
Do not use water with chemical
Service life and the applicable product warranty period start on the date of purchase
additives
or the date of manufacture (if the purchase date cannot be established).
Use common tap water or half tap
You can determine manufacture date by the serial number on the identification label
water and half distilled water
on the housing of the device. The serial number consists of 13 digits. The 6th and 7th
Carry out self-cleaning procedure. digits of the serial number refer to the month, whereas the 8th digit refers to the year
Always empty water tank after use
of manufacture.
Service life of the product, established by the manufacturer is 3 years from the date of
Refer to "Fabric Ironing Chart" and
purchase, provided that the appliance is used and maintained in accordance with the
garment labels to select correct
temperature user manual and applicable technical standards.
Clean the soleplate. Thoroughly
rinse the garment to remove any
traces of detergent residue that may
damage the soleplate
Turn temperature control dial into
Old appliances must not be disposed with other household waste but must be col-
• • or • • • position
lected separately. Municipal disposal of recyclable wastes is free of charge. The owners
of old appliances are required to bring it to a waste facility centre. With this little extra
Increase intervals between steam
effort, you can help to ensure that valuable raw materials are recycled and pollutants
shots
are treated as appropriate.
Use special iron support. Always
This appliance is labelled in accordance with European Directive 2012/19/EU — concern-
store the iron in vertical position
ing used electrical and electronic appliances (waste electrical and electronic equipment
WEEE).
Avoid placing the iron on sharp
objects, such as zip fasteners, but- The guideline determines the framework for the return and recycling of used appli-
tons, or rivets during ironing to
ances as applicable throughout the EU.
prevent damage to soleplate
Environmentally friendly disposal (WEEE)
The packaging, user manual and the device itself shall be taken to the
applicable collection point for the recycling of electrical and electronic
equipment. Do not throw away the electronic waste to help protect the
environment.
RI-C244-E
GBR
9