Télécharger Imprimer la page

WAGNER Airless Sprayer Plus Traduction Du Mode D'emploi Original page 19

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Airless Sprayer Plus
Congratulations for the purchase of your
WAGNER Airless high pressure spray gun.
Read this manual carefully before the initial use of this
equipment and observe the safety instructions. Keep
manual and safety instructions carefully stored.
You have purchased a quality product which requires careful
maintenance and care in order to function perfectly.
Important! After each use, the equipment should be
cleaned.
Not cleaning the equipment leads to malfunctioning! For
faults caused by crud, no guarantee claim will be granted.
In case of malfunctioning, check the cleaned equipment once
again prior to sending it in to the service department.
Explanation of symbols used
Indicates an immediate danger. Unless
avoided, death or serious injuries will
result.
Danger
Indicates tips for use and other
i
particularly useful information.
Wear suitable ear protection when
working.
Wear suitable respiratory equipment
when working.
Wear suitable safety gloves when
working.
General Safety Instructions
Warning!
Read all safety notifications and instructions.
Failure to comply with the safety notifications
and instructions provided may result in electric
shock, fire and/or serious injury. The term
Danger
"power tool" used below covers both mains-
operated power tools (with mains lead) and
accumulator-operated power tools (without
mains lead).
1. Work area safety
a) Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
b) Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
c) Keep children and bystanders away while
operating a power tool. Distractions can cause you
to lose control.
2. Electrical Safety
a) Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets will
reduce risk of electric shock.
b) Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
c) Do not expose power tools to rain or wet
conditions. Water entering a power tool will increase
the risk of electric shock.
d) Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges or
moving parts. Damaged or entangled cords increase
the risk of electric shock.
e) When operating a power tool outdoors, use an
extension cord suitable for outdoor use. Use of a
cord suitable for outdoor use reduces the risk of electric
shock.
f) If operating a power tool in a damp location is
unavoidable, use a residual current device (RCD)
protected supply. Use of an RCD reduces the risk of
electric shock.
3. Personal safety
a) Stay alert, watch what you are doing and use
common sense when operating a power tool. Do
not use a power tool while you are tired or under
the influence of drugs, alcohol or medication. A
moment of inattention while operating power tools
may result in serious personal injury.
b) Use personal protective equipment. Always
wear eye protection. Protective equipment such as
dust mask, non-skid safety shoes, hard hat, or hearing
protection used for appropriate conditions will reduce
personal injuries.
c) Prevent unintentional starting. Ensure the
switch is in the off-position before connecting
to power source and/or battery pack, picking up
or carrying the tool. Carrying power tools with your
finger on the switch or energising power tools that
have the switch on invites accidents.
d) Remove any adjusting key or wrench before
turning the power tool on. A wrench or a key left
attached to a rotating part of the power tool may
result in personal injury.
e) Do not overreach. Keep proper footing and
balance at all times. This enables better control of
the power tool in unexpected situations.
f) Dress properly. Do not wear loose clothing or
jewellery. Keep your hair, clothing and gloves
away from moving parts. Loose clothes, jewellery or
long hair can be caught in moving parts.
GB
19

Publicité

loading

Ce manuel est également adapté pour:

0418