Chimney Assembly - Klarstein Victoria Mode D'emploi

EN
32
Connections to ducted version air exhaust system
When installing the ducted version, connect the hood to the chimney using either a flexible
or rigid pipe 150 mm or 120 mm, the choice of which is left to the installer.
• If to install a 120 mm air exhaust connection, insert the reducer flange on the hood
body outlet.
• Fix the pipe in position using sufficient pipe clamps (not supplied).
• Remove possible charcoal filters.

CHIMNEY ASSEMBLY

The chimney can only be installed with exhausting hood.
Lower Decorative Chimney
• Fix the Lower Decorative Chimney to the hood body with 2 screws (4.2x9.5)
supplied with the hood.
2 Screws
(4,2x9,5)