Troubleshooting - Klarstein VICTORIA Mode D'emploi

EN
36
Replacement Light
Ø Max Power
70 mm 1,5 W
Reinstall LED Light Module
1 Press LED light on the front of front plate, install the LED light on the front plate.
2 Connect the terminal of LED light and light leads.
3 Carefully fasten the 2 screws on the front plate ,reinstall the grease filter.

TROUBLESHOOTING

Problem
Light on, but motor does
not work
Both light and motor do
not work
Oil leakage
Voltage
DC 12 V
Cause
The blades are blocked.
The capacitor is damaged.
The motor is damaged.
The internal wiring f motor
is cut off/disconnected.
An unpleasant smell may
be produced.
Apart from the above mentioned, check the following:
Light damaged.
Power cord loose.
Outlet and the air
ventilation entrance are
not tightly sealed.
ILCOS D
Picture
code
DSR-
1.5-S-70
Solution
Check the blades.
Replace capacitor.
Replace motor.
Replace lights.
Connect the wires as the
electric diagram.
Take down the outlet and
seal with glue.