Nice HSRE12 Instructions Pour L'installation page 5

Control device
Detector (all models)
Door and window opening
detectors (HSDID11)
with alarm signal
on opening and closing
(alarm end)
Remote control
Keypad
Control panel (with one
of the 16 radio controls
configured as: "PULSE")
Control panel (with one
of the 16 radio controls
configured as "ON-OFF")
Table 1: memorising devices on HSRE12
Receiver output
On each alarm signal: activates the timed
output
The status of the output (but not of the led)
following opening and closing
of the door/window
Keys = On; key = Off
the relay output is always bistable (Off-On)
Key : activates the timed output
Key (if configured as command key):
activates the timed output
Preceded by a code of 1 to 4 digits:
Key = On; Key = Off
Key : toggle operation each time
pressed
Key : activates the timed output
Key : after 3 s activates the timed output
Remote commands "On" or "Off": activate the
timed output
The remote "ON" commands activate the
output; the "OFF" commands deactivate it
Action to memorise command
Insert the battery in the detector
On the detector, set Dip Switch 1 to On
Insert the battery in the detector
Press keys and simultaneously
Press for 10 seconds
Press for 10 seconds
Enter a code of 1 to 4 digits then press
keys and simultaneously
Press for 10 seconds
Press for 10 seconds
Press for 13 seconds
On the control panel, perform the radio
control configuration procedure; select
"PULSE" and press [OK]
On the control panel, perform the radio
control configuration procedure; select
"ON-OFF" and press [OK]
English - 3