Nice HSRE12 Instructions Pour L'installation page 4

outputs; fig. 1 shows the layout of the outputs on the termi-
nal board.
2.1.1 - Output configuration
Fig. 2 indicates the electrical circuit of the outputs:
- the equivalent circuit (can be considered an electrical con-
tact of a relay, voltage-free;
- the real circuit can be considered the presence of a 100 Ω
resistance in series with the contact;
- the schematic circuit produced with a special component
named "OptoMOS® Relays".
Fig. 3 shows the wiring diagram for a relay, if the power on
output needs to be increased.
2.1.2 - RES input
The "RES" input enables management of activation and
deactivation of the receiver, according to the configuration of
Dip Switch N°1; see Table 3.
If Dip Switch N°4 is set to ON, the alarm and signal outputs
are activated both with the receiver activated or deactivated.
If Dip Switch N°4 is set to OFF, the outputs are only activated
if the receiver is activated; see Table 3.
To activate the alarm memory (Dip Switch N°2 = ON) see
Table 3.
2.1.3 - Electrical power supply
The receiver is powered with a standard voltage of 12 Vdc,
connecting terminals ALIM + (+POS) and ALIM - (GND), as
shown in fig. 1. The power negative (GND) is also available
on a further 2 terminals.
3 - PROGRAMMING
To enable the control devices to activate the outputs of
2 - English
HSRE12, the device codes must be memorised on the
receiver.
3.1 - Memorising devices on the HSRE12 receiver
HSRE12 (fig. 4)
To memorise a device, proceed as follows:
01. Press S1 (PROG) to activate programming mode; a
BEEP indicates the start of programming;
02. Select the required output by pressing S2 repeatedly
(SEL.CAN); the relative led of the ALL output illuminates;
03. Memorise one or more devices for each output, per-
forming the action specified in Table 1;
04. A BEEP confirms correct programming, 3 BEEPS indi-
cate that the device has already been memorised;
05. To memorise other devices on other outputs, repeat
points 02 and 03;
06. The memorisation phase terminates by pressing S1 and
S2 simultaneously or after 1 minute of inactivity.
Caution! It is not possible to memorise devices with a
timed function together with devices with an ON-OFF
function on the same output.