AEG S63800KMX0 Notice D'utilisation page 33

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

All manuals and user guides at all-guides.com
Problem
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the COOLMATIC
switch, or after changing
the temperature.
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
Temperature cannot be
set .
The temperature in the
appliance is too low/high.
The temperature in the re-
frigerator is too high.
Possible cause
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is in stand-by.
The lamp is defective.
The temperature is not set cor-
rectly.
The door is not closed correctly.
The door has been opened too
frequently.
The product temperature is too
high.
The room temperature is too
high.
This is normal, no error has oc-
curred.
During the automatic defrosting
process, frost defrosts on the
rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
COOLMATIC function switched
on.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
What to do if...
Solution
Connect a different electrical ap-
pliance to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature be-
fore storage.
Decrease the room temperature.
The compressor starts after a pe-
riod of time.
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Switch off COOLMATIC manually,
or wait to set the temperature
until the function has reset auto-
matically. Refer to "COOLMATIC
function"..
Set a higher/lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
33

Publicité

Table des Matières
loading

Table des Matières