Installation - Alpine CDA-9851 Mode D'emploi

Installation

Caution
When you install this unit in your car, do not remove the
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
Caution
Do not block the unit's fan or heat sink, thus preventing air
circulation. If blocked, heat will accumulate inside the unit and
may cause a fire.
Air ventilation hole
(Rear of CDA-9851)
1
Mounting Sleeve
(Included)
this unit
Remove the Detachable Front Panel (refer to page 7).
Slide mounting sleeve from main unit (see "Removal"
on this page).
2
Hex Nut (M5)
Metal
Mounting
Strap
Chassis
Ground Lead
Reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground lead of the
unit to a clean metal spot using a screw (*
attached to the vehicle's chassis.
2
• For the screw marked "* ", use an appropriate screw for the
chosen mounting location.
All manuals and user guides at all-guides.com
Metal plate
Detachable
Front panel
Dashboard
Screw
* 2
Bolt Stud
* 1
this unit
1 ) already
Connect each input lead coming from an amplifier
or equalizer to the corresponding output lead
coming from the left rear of the CDA-9851. Connect
all other leads of the CDA-9851 according to details
described in the CONNECTlONS section.
3
Slide the CDA-9851 into the dashboard until it
clicks. This ensures that the unit is properly locked
and will not accidentally come out from the
dashboard. Install the detachable front panel.
Removal
1 Remove the detachable front panel.
2 Insert the optional brackets into the back, along the
guides on either side of the unit. The unit can now be
removed from the mounting sleeve.
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
this unit
3
*
Ground Lead
• Secure the ground lead of the unit to a clean metal spot using a
screw (* 3 ) already attached to the vehicle's chassis.
This unit
Bracket
(Included)
Face Plate
Screws (M5 × 8)
(Included)
Mounting Bracket
31
-EN