Ryobi P2009 Manuel D'utilisation page 9

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING:
Never use blades, flailing devices, wire, or rope on this
product. Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
WARNING:
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or a quali-
fied service center for assistance.
TO INSTALL BATTERY PACK
See Figure 4.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured before
beginning operation.
TO REMOVE BATTERY PACK
See Figure 4.
 Depress the latches on each side of the battery pack.
 Remove battery pack from the trimmer.
WARNING:
To avoid serious personal injury, always remove the
battery pack and keep hands clear of the lock-out button
when carrying or transporting the tool.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
STARTING/STOPPING THE STRING TRIMMER
See Figure 5.
To start:
 Select the desired operating speed (HIGH or LOW).
 Press and hold the lock-out button.
 Depress the switch trigger.
To stop:
 Release the switch trigger to stop the string trimmer.
 Upon release of the switch trigger, the lock-out button
will automatically reset to the locked position.
OPERATION
ADJUSTING THE FRONT HANDLE
See Figure 6.
The angle of the front handle can be adjusted 180°.
 Remove the battery pack.
 Set the trimmer on a flat surface and turn the wing bolt
counterclockwise to loosen the handle.
 Adjust the handle as desired.
 Turn the bolt clockwise until the handle is securely
tightened before reinstalling the battery pack.
OPERATING THE TRIMMER
See Figure 7.
Follow these tips when using the string trimmer:
 Hold the trimmer with your right hand on the rear handle
and your left hand on the front handle.
 Keep a firm grip with both hands while in operation.
 Trimmer should be held at a comfortable position with
the rear handle about hip height.
 Cut tall grass from the top down. This will prevent grass
from wrapping around the boom housing and string head
which may cause damage from overheating.
If grass becomes wrapped around the string head:
 Remove the battery pack.
 Remove the grass.
WARNING:
Always hold the string trimmer away from the body
keeping clearance between the body and the string
trimmer. Any contact with the string trimmer cutting head
while operating can result in serious personal injury.
CUTTING TIPS
See Figure 8.
 Keep the trimmer tilted toward the area being cut; this is
the best cutting area.
 The string trimmer cuts when passing the unit from right
to left. This will avoid throwing debris at the operator.
Avoid cutting in the dangerous area shown in figure 8.
 Use the tip of the line to do the cutting; do not force string
head into uncut grass.
 Wire and picket fences cause extra line wear, even
breakage. Stone and brick walls, curbs, and wood may
wear line rapidly.
 Avoid trees and shrubs. Tree bark, wood moldings, siding,
and fence posts can easily be damaged by the line.
7 — English

Publicité

Table des Matières
loading

Table des Matières